Hitachi Koki Tanaka TEA-500 Mode D'emploi page 8

Drilling safety
• Do not drill any material other than that for which is intended.
• Inspect the area to be drilled before each use. Remove objects
which can be thrown or become entangled.
• For respiratory protection, wear an aerosol protection mask when
drilling the area after insecticide is scattered.
• Keep others including children, animals, bystanders and helpers
outside the 5 m hazard zone. Stop the engine immediately if you
are approached.
• This machine requires two operators at all times. Never attempt
to use this machine with only one operator, or to alter the controls
to allow use by only one operator.
• Hold the unit/machine firmly with both hands.
• Keep firm footing and balance. Do not over-reach.
• Keep all parts of your body away from the muffler and drilling
attachment when the engine is running.
• When relocating to a new work area, be sure to shut off the
machine and ensure that all cutting attachments are stopped.
• Never place the machine on the ground when running.
• Always ensure that the engine is shut off and any cutting
attachments have completely stopped before clearing debris or
removing grass from the cutting attachment.
• Always carry a first-aid kit when operating any power equipment.
• Never start or run the engine inside a closed room or building
and/or near the inflammable liquid. Breathing exhaust fumes can
kill.
Maintenance safety
• Maintain the unit/machine according to recommended
procedures.
• Disconnect the spark plug before performing maintenance except
for carburetor adjustments.
• Keep others away when making carburetor adjustments.
• Use only genuine Tanaka replacement parts as recommended by
the manufacturer.
CAUTION!
Do not disassemble the recoil starter. You may get a possibility of
personal injury with recoil spring.
Transport and storage
• Carry the unit/machine by hand with the engine stopped and the
muffler away from your body.
• Allow the engine to cool, empty the fuel tank, and secure the unit/
machine before storing or transporting in a vehicle.
• Empty the fuel tank before storing the unit/machine, It is
recommended that the fuel be emptied after each use. If fuel is
left in the tank, store so fuel will not leak.
• Store unit/machine out of the reach of children.
• Clean and maintenance the unit carefully and store it in a dry
place
• Make sure engine switch is off when transporting or storing.
• When transporting in a vehicle or storage, cover bit with bit cover
or rug.
GB-4
If situations occur which are not covered in this manual, take
care and use common sense. Contact Tanaka dealer if you need
assistance. Pay special attention to statements preceded by the
following words:
WARNING!
Indicates a strong possibility of severe personal injury or loss
of life, if instructions are not followed.
CAUTION!
Indicates a possibility of personal injury or equipment damage, if
instructions are not followed.
NOTE!
Helpful information for correct function and use.