Technical Specifications - Dörr SnapShot Limited 5.0 Notice D'utilisation

Table des Matières

Les langues disponibles

6. We recommend to direct the camera in a way that the object will be in the center of the picture. You may have to re-adjust

the camera and take another test shot.

TIP:

To change the camera angle you can use e.g. a small wooden wedge between camera and trunk.

7. Once the camera position is correct, the ﬁ xing belt can be tightened to hold the camera ﬁ rmly.

8. Switch the camera o after test shooting.

START SURVEILLANCE

Slide the On/O button (9) to "ON" position and close the camera housing. After 15-30 seconds camera is ready and it

records according to your settings and upon movement.

CAMERA CHECK UP

Options to check if the camera has taken pictures:

1. Open the camera housing and turn o camera. After about 2 seconds slide the On/O button (9) to "SETUP" position.

2. The LCD display (5) shows the start screen. The lower line shows the number of pictures taken and the remaining

memory. Example: [0034/1846].

3. It is recommended to check the battery status as well. When capacity goes down, it will be more di cult to achieve

correctly illuminated night shots. In case of doubt, replace batteries by new ones.