System Settings; Time Stamp - Dörr SnapShot Limited 5.0 Notice D'utilisation

TIMER (START-STOP)
The camera only takes photos/videos within the selected time frame. In the remaining time camera does not take photos/
videos and does not react to motion (same for "Time Lapse" mode).
1. Press the arrow button (7) ‚ to select "Start-Stop"
2. Press the arrow buttons (7) ƒ or „ to select "O " or "On"
3. To deactivate select "O " and confi rm with „OK" button (8).
4. To activate select "On" and confi rm with „OK" button (8). Display shows two fi elds to enter the start and stop time:
With the arrow buttons (7)  or ‚ enter the start time
With the arrow button (7) „ switch to the "Stop" fi eld. With the arrow buttons (7)  or ‚ enter the stop time.
5. After setting save with „OK" button (8).
Now the camera only works in the selected time frame.
SYS

SYSTEM SETTINGS

DATE AND TIME
The date has to be set in the format dd.mm.yyyy. Time has to be set in 24 hours format.
1. Press the arrow button (7) ‚ to select "Enter". Press the "OK" button (8) to enter the setting mode:
2. With the arrow buttons (7)  or ‚ enter the date.
3. With the arrow button (7) „ switch to the next number.
4. After setting save with „OK" button (8).

TIME STAMP

Choose if time and date are shown on pictures.
1. Press the arrow button (7) ‚ to select "Time Stamp"
2. Press the arrow buttons (7) ƒ or „ to select "On" or "O ".
3. Save with „OK" button (8).
LANGUAGE
Choose either German, English or French language for the camera menu.
1. Press the arrow button (7) ‚ to select "Language"
2. Press the arrow buttons (7) ƒ or „ to select "English", "German" or "French"
3. Save with „OK" button (8).
BEEP TONE
Activate or deactivate the beep tone for the control buttons.
1. Press the arrow button (7) ‚ to select "Beep"
2. Press the arrow buttons (7) ƒ or „ to select "O " or "On"
3. Save with „OK" button (8).
OVERWRITE FUNCTION
Camera may overwrite old pictures with new ones when SD card is full or alternatively quit function.
1. Press the arrow button (7) ‚ to select "Over Write"
2. Press the arrow buttons (7) ƒ or „ to select "O " or "On"
3. Save with „OK" button (8).
13