Fitting/Removing The Extraction Device Adapter; Tips And Tricks; Guiding The Paint Remover; Presenting The Tool To The Edge Of A Workpiece - Metabo LF 724 S Notice Originale

ENGLISH
Remember to remove the ring
spanner!
6.4 Fitting/removing the extraction
device adapter
For dust extraction purposes use a Metabo
suction unit or some other suitable extraction
device.
Fitting
Push the extraction device adapter (6) into the
extraction nozzle (5) until it engages in position.
The required extraction device can now be
connected to the 35 mm dia. tube adapter.
Removing
Press in the tongue and pull the adapter (6)
out of the extraction nozzle (5).
7 Tips Tricks
and
7.1

Guiding the paint remover

Always use two hands to guide the paint
remover backwards where possible over the
surface of the workpiece being processed.
When holding the paint remover down, ensure
that the pressure exerted is distributed evenly
over the area of the planing base.
7.2 Presenting the tool to the edge
of a workpiece
A
See diagram A: Hold the paint remover parallel
with the surface of the workpiece. When
presenting the tool, ensure that the planing
base is in contact with the largest possible
area of the surface.
14
7.3

Procedure

B
See diagram B: Guide the paint remover in
such a way that the planing base (9) is always
positioned on the surface that has not yet
been processed. If you proceed as shown,
a narrow section is left over.
See diagram C: You can remove this section
by setting the cutting depth to 0 mm (see
section 6.3) and now always guide the planing
base over the processed surface.
7.4

Smoothing

Reduce the cutting depth to achieve a smooth
surface finish.

8 Maintenance

Be aware of the risk of injury
presented by the sharp cutting edges
of the reversible blades. Do not
attempt any maintenance operation
until the cutterhead has come to rest.
Switch the paint remover off and
disconnect from the mains supply.
Always wear personal protective
equipment, safety goggles, ear
protectors, protective gloves and
heavy-duty footwear during work and
for all setting, conversion and
maintenance tasks!
8.1

Cleaning the reversible blades

Paint, etc. can lodge under the cutting edges
of the reversible blades. If this occurs, clear
the cutting edges of the blades with the sharp-
pointed tool.
8.2

Turning/replacing the reversible blades

Use original Metabo reversible
blades only.
Order No.: 6.31720 (4 units)
Order No.: 6.31660 (10 units)
C