Saw Chain And Guide Bar - Craftsman CMECS614 Guide D'utilisation

English
1. Always start a cut with the saw chain running at
full speed.
2. Place the bottom spike
area of the initial cut as shown in Fig. O.
Fig. O
22
3. Turn the chain saw on then rotate the saw chain and bar
down into the tree, using the spike as a hinge.
4. Once the chain saw gets to a 45° angle, level the chain
saw again and repeat steps until you cut fully through.
5. When the tree is supported along its entire length, make
a cut from the top (overbuck), but avoid cutting the
earth as this will dull your saw quickly.
Fig. P- When supported at one end
•
First, cut 1/3 the diameter from the underside
(underbuck). Then make the finishing cut by
overbucking to meet the first cut.
Fig. P
2
1
• Fig. Q- When supported at both ends. First, cut 1/3
down from the top overbuck. Then make the finished
cut by underbucking the lower 2/3 to meet the first cut.
10
22 of the chain saw behind the
CUT FROM TOP (OVERBUCK)
AVOID CUTTING EARTH
2nd CUT OVERBUCK
(2/3 DIAMETER)
TO MEET 1st CUT
(TO AVOID PINCHING)
1st CUT UNDERBUCK
(1/3 DIAMETER)
AVOID SPLINTERING
Fig. Q
• Fig. R- When on a slope always stand on the uphill
side of the log. When "cutting through", to maintain
complete control reduce the cutting pressure near the
end of the cut without relaxing your grip on the chain
saw handles. Don't let the chain contact the ground.
After completing the cut, wait for the saw chain to stop
before you move the chain saw. Always stop the motor
before moving from cut to cut.
Fig. R
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Regular maintenance ensures a long effective life for your
chain saw.

Saw Chain and Guide Bar

After every few hours of use, remove the guide bar and
clean thoroughly.
Saw Chain Sharpening (Fig. S, T, U)

CAUTION: Sharp chain. Always wear protective
gloves when handling the chain. The chain is sharp
and can cut you when it is not running.

WARNING: Sharp moving chain. To prevent
accidental operation, ensure the tool is unplugged
before performing the following operations. Failure to
do this could result in serious personal injury.
nOTE: The cutters will dull immediately if they touch the
ground or a nail while cutting.
1st CUT OVERBUCK
(1/3 DIAMETER)
TO AVOID SPLINTERING
2nd CUT UNDERBUCK
(2/3 DIAMETER)
TO MEET 1st CUT
(TO AVOID PINCHING)