Using The Drier; Description Of The Control Panel - Ardo SM2239 Mode D'emploi

18

DESCRIPTION OF THE CONTROL PANEL

11
P. Programmer Knob. Used to select the required pro-
grammes according to the type of fabric and drying
needs. In addition to switching off the display, the
STOP button also resets the appliance. If, for any
reason, you want to change the programme or add
more washing to the load, simply place the program-
mer knob in the "STOP" position. Then re-position the
knob on the required program and press the "START"
button.
NB. Warning!! only use this function if strictly neces-
sary and then only if the programme to reset has not
been running for more than 3 minutes.
N.B. On some models fi tted with a Delay function,
when the function is enabled or at the end of the
cycle, the backlit display will switch off after a few
minutes. Pressing any button will switch the display
light on again.
S. Start Button. Press this button to start the programmed
drying cycle.
L . Start LED. Off indicates the "STOP" position. On fi xed
S
indicates the programme is running. Fast fl ashing
indicates the set programme is ready to start. Slow
fl ashing indicates the end of the drying programme.
U. Drying selector buttons (+/-). These are used to select
the degree of dampness on electronically controlled
programmes and the time on manual programmes.
Not all the options are available for all programmes.(see:
"PROGRAMME TABLE")
L . There are 4 icons for the electronically controlled
A
drying programme. The selected icon will fl ash while
the other 3 remain lit. When the cycle starts, only the
selected icon remains lit.
C . Drier timer. Displays the set time in steps of 20 min-
T
utes, up to a maximum of 2 hours and 40 minutes for
the cotton programme and 2 hours for the synthetics
programme.
GB

USING THE DRIER

C
C L
R A
Ih. Ia. Ic.
R H A C U
C. Beep silencer button. Disables the beep function,
which would otherwise be permanently enabled.
The selection remains memorised even when the
appliance is switched off.
The beeps signal as follows:
1 long beep (cycle started)
4 long beeps (cycle completed)
4 short beeps (drum rotating for anti-crease func-
tion)
A. Anti-crease button. Activates a function that, at the
end of the drying cycle, rotates the drum and the
washing loaded in it in one direction then in the other
for a further sixty minutes to reduce creasing. Each
rotation is signalled by short beeps.
H. Drying delay anti-crease button. This rotates the
washing in the drum during the delayed start in
order to reduce creasing.
lh. la. lc. The beeper, anti-crease and delayed start
icons appearing on the display indicate that the
functions are active.
R. Delayed start button. Used to delay drier start-up for
up to a maximum of 16 hours. Each time the button
is pressed, the start is delayed for one hour. When
the START button is pressed, the letter h will fl ash
on the display signalling that the function has been
activated. The machine will wait for the number of
hours set to elapse and then start the drying cycle
automatically. If the power supply is interrupted while
the delayed start function is active, the function itself
will be annulled. Pressing the START button will start
the drying cycle immediately.
C . Delayed start counter. Displays the delay time set in
R
steps of one hour up to a maximum of 16 hours.
L P
T
S
S
SM2239