Electrical Connection; Opening The Door And Changing The Opening Direction - Ardo SM2239 Mode D'emploi

8
Important: On completion of the drying cycle, disconnect the appliance from the mains supply
to prevent young children from operating the drier.

OPENING THE DOOR AND CHANGING THE OPENING DIRECTION

9
10
SM2239
INSTALLING THE APPLIANCE

ELECTRICAL CONNECTION

Make sure that the voltage indicated on the identifi cation plate attached to the
back of the appliance corresponds to that of the mains supply.
On completion of the installation, the appliance must be connected to the mains
supply through a two-pole switch.
All cutouts, electric wiring and mains sockets must have a rating such that enables
them to support the maximum load indicated on the identifi cation plate.
The mains supply to which the appliance is connected must be fi tted with an
earthing system. If this is not the case, the manufacturer will not be held liable
for any incidents that may occur (fi g. 8).
If the power supply cable is damaged in any way, contact the nearest customer
service centre.
The drier must not be connected to the mains supply using indirect methods
such as extension leads or multiple adapters.
Position the appliance so that the power supply cable is easily accessible for
disconnection when the need arises.
▼ Press on the right side of the door (fi g. 9) to open it. If the direction of the door
opening has been changed, press the left side.
▼ The opening direction of the door opening can be modifi ed according to needs
(fi g. 10).
N.B.: This operation must only be carried out by a qualifi ed technician.
Contact the customer service centre.
17
GB