Inserting/Replacing Batteries, Battery Icon; Activating And Setting The Date/Time; Attaching The Cuff - uebe visomat handy Mode D'emploi

C

5. Inserting/replacing batteries, battery icon

• Remove the cover of the battery compartment on the side of
the unit.
• Remove the old batteries from the device and insert the new
ones. Please ensure correct polarity (marking in battery com-
partment).
• Close the battery compartment by clipping the battery cover
back into the device.
When the "empty battery " symbol first appears in the display,
you are still able to take around 30 measurements. Please re-
place the batteries within this time frame.

6. Activating and setting the date/time

Activating and deactivating the date/time function
To activate the date/time function, press the Start/Stop button
and then immediately, while the full display is visible, the Memory
button. This function can be deactivated at any time in the same
way.
When the date/time function is activated, the device continues
to display the time even when it is switched off. The power con-
sumption for this is extremely low.
Setting the date/time
The four-digit number representing the year ap-
pears in the display first (Figure 1). Press the Memo-
ry button to set the year. Press the Start/Stop button
to confirm the selected year and proceed to setting
the date (Figure 2).
EN-40
Operating the unit
Figure 1
Operating the unit
Set the month with the Memory but-
ton and confirm this with the Start/
Stop button. Set the day, hours and
minutes in the same way (Figure 2, Fig-
ure 3).
Changing the date/time
To change the date and time, take the batteries out and wait until
the display goes off. Then re-insert the batteries and reset the
date and time.
After replacing the batteries, you will have to reset the date and
time.

7. Attaching the cuff

The special double-preformed comfort cuff is easy to attach and
ensures a perfect fit during measurement. The materials used
are tested for skin compatibility according to ISO 10993.
• Clear the wrist from all clothing or watches/jewellery since
this may disturb the blood flow in the arm as it may impair
the blood pressure at the place of measurement.
• Slide the device onto the centre of the
inside of the forearm, directly on the
wrist. The palm of your hand should be
facing upwards. The distance between
the wrist and the upper edge of the cuff
should be 5–10 mm.
• Fasten the cuff using the hook and loop fastening.
The shape of the cuff is optimized to sit very tightly in order to
avoid possible measurement errors.
C
Figure 2 Figure 3
EN-41