Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
2 / INSTALLING YOUR APPLIANCE
the right position.
- Connect a tube to the device air outlet, on such
a height to reach the top of the pensile cupboard
(the tube is not provided).
- Install the filters support again.
- Make the electrical connection.

Ducting mode

- Remove the grease filters: press inward on the
clamp at the handle and pull the filter downward
(Fig. 3).
- Only for SHG86-SHG88-SHG89 models: Take
the filters support away moving the 2 lateral locks
C (Fig.4).
- Cut a hole in the bottom of the pensile cupboard
in order to settle the appliance (Fig. 5). The pen-
sile cupboard bottom hob must be between 15
and I 18 mm thick.
Check that the fixing tabs (Fig. 6) to the wall unit
are positioned at a height suited to the thickness
of the bottom of the wall unit. If this distance is
less than the thickness, increase it by unscrewing
the 2 corresponding screws inside the hood.
- Prepare the connection to the mains, near the
appliance.
- Insert the appliance in the hole.
- Assembly for SHG86-SHG88-SHG89 models
(Fig. 8): fit the appliance to the pensile cupboard
by means of 4 screws.
- Assembly for SHG879 model (Fig. 9): tighten the
2 screws inside the appliance until it fits snug on
the bottom of the wall unit. Do not tighten the 2
screws strongly to maintain the metallic clamps in
the right position.
Connect the air evacuation pipe with the device air
outlet (Fig. 10): use a flexible pipe and block it in
the device air outlet through a metallic clamp (the
25
fig. 7
fig. 8
fig. 9

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Shg88Shg89Shg879

Table des Matières