sauter SHG86 Guide D'installation Et D'utilisation page 27

2 / INSTALLING YOUR APPLIANCE
tube and the clamp are not provided).
- Take away the coal filters (F) and the filters-stop
(M) which are placed on the grease filter (Fig. 11).
- Install the filters support and the grease filters
again.
- Make the electrical connection.
Non-return valve
In the case of installation with air evacuation
to the outside, fitting the non-return valve
prevents the wind from entering and the air
from returning.
Caution: Before fastening the air exhaust
pipe to the motor, check that the non-return
valve on the air vent can move freely.
Warning
This is the filtering version of your
cooker hood; you must first remove the
charcoal filters.
Tip
For optimal use of your appliance, we
recommend that you connect the hood to a
125 mm-diameter flue (not delivered with the
appliance). Minimise the number of angles
and bends and the lengths of the flue. In
the event that the hood will be operated
using out-door evacuation, you should
ensure a sufficient inflow of fresh air to
avoid a pressure deficiency in the room.
26
EN
fig. 10
fig. 11