Installing Your Appliance; Using The Ducting Mode; Using The Filtering Mode - sauter SHC621 Guide D'installation Et D'utilisation

EN

2 / INSTALLING YOUR APPLIANCE

- The appliance must be unplugged during installation or when any repairs or maintenance work is
being performed.
- Ensure that the network voltage corresponds to the voltage noted on the identification plate located
inside the hood.
- If the electrical installation at your residence requires any changes in order to hook up your
Appliance, call upon a professional electrician.
- If the hood is being used in evacuation mode, do not connect the appliance to a combustion gas
exhaust duct (boiler, chimney, etc.) or to a CMV (controlled mechanical ventilation) system.
- Under no circumstances should the exhaust duct empty into the attic.
- Install the hood at safe distance of at least 65 cm from an cooking hob.
This appliance can be installed in either duction version or filtering version.
The appliance is supplied in the filtering version, the charcoal filter is installed (Ref.SHK26AF1 for the
models SHC621-SHC623-SHC634-SHC626, Ref. SHK90AF1 for the model SHC690).

USING THE DUCTING MODE

•
The exhaust duct will must be locked on to and
fixed to the 123-mm diameter flue (Fig. 1).
Steam and cooking smells are whisked directly
outside through an extraction flue from the top
of the hood. The use of charcoal filters is not
required.
Your cooker hood is a filtering version. All you
need to do is to remove the charcoal filters first.

USING THE FILTERING MODE

•
The air and steam coming from the appliance
are purified by the charcoal filters and then
circulated through the body of the appliance
(Fig.2).
Warning
CHECK THAT THE DUCTING-FILTERING
LEVER IS IN THE RIGHT POSITION (fig. 3):
the lever is found on the motor unit and must
be positioned on the symbol (E) in the case
of installation in ducting version, on the
symbol (R) in the case of installation in
filtering version.
E
21
fig. 1
fig. 2
R
fig. 3