Ibiza Light STROBE-150 Manuel D'utilisation page 3

INSTALLATION INSTRUCTIONS
CAUTION:
1. Do not operate this device with open cover!
2. Only install the lamp with the device unplugged from the mains!
MOUNTING
Orientation
This fixture may be mounted in a 90°degree angle only, provided there is adequate room for ventilation
RIGGING
It is important never to obstruct the fan or vents pathway. Mount the fixture using, a suitable "C" or "O" type clamp.
Adjust the angle of the fixture by loosening both knobs and tilting the fixture. After finding the desired position,
retighten both knobs.
When selecting installation location, take into consideration routine maintenance.
Safety cables must always be used.
Never mount in places where the fixture will be exposed to rain, high humidity, extreme temperature changes or
restricted ventilation.
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer
or his service agent or a similar qualified person in order to avoid a hazard.
Fuse replacement:
Warnings: Disconnect the power cord before replacing a fuse and always replace with the same type fuse.
With your hands, unscrew the fuse holder from its housing, remove the damaged fuse from its holder and replace
with exactly the same type of fuse. Screw the fuse holder back in its place and reconnect power.
Exterior surface temperature under normal operating conditions is 40°C.
Connection of Power and Wire
The supplied plug should be used between the connection of light and power, and please confirm if the rated voltage
and frequency is accordance with the power supply. Every light is fitted with an independent power switch. It will be
convenient for you to turn ON or OFF every light. The required input voltage and frequency is 230Vac～50Hz. The
power cable, if damaged, should only be replaced by a service agent or professional. Please use the same type of
power wire for replacement.
Note: the ground wire (yellow/green double-color wire) must be safely connected, the electronic installation must be
in accordance with the related standards
CAUTION: When installing the device, make sure there is no highly inflammable material within a distance of
min.1m!
The following points have to be considered during the inspection:
All screws for installing the devices or parts of the device have to be tightly connected ad must not be corroded.
There must not be any deformations on the housing, glass pane, fixations and installation spots.
The electric power supply cables must not show any damage, material fatigue or sediments. Further instructions
depending on the installation spot and usage have to be adhered to by a skilled installer and any safety problems
have to be removed.
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol or solvents.
© Copyright LOTRONIC 2011 STROBE150 Page 3