Items Supplied; Power Supply; Technical Data; Startup And Operation - Elem Garden Technic THE501-510 Traduction Des Instructions D'origine

In accordance with essential
applicable safety standards of
European directives
This appliance is double insulated;
therefore no earth wire is required.
Always check that the power
supply corresponds to the voltage
on the rating plate.
WARNING: Packaging
materials are not toys!
Children must not play with
plastic bags! Danger of
ELECTRICAL SAFETY
Always check that the power
supply corresponds to the
voltage on the rating plate.

Items supplied

1 Cutter rail
2 Hand guard
3 Guide handle with button switch
4 Handle with button switch
5 Eyelet for extension cable
6 Power cable
7 Storage case
Fitting the hand guard
It is prohibited to use the
hedge trimmer without

Technical data

Voltage
Power consumption
Cutting length
Cutter rail length
Tooth spacing
Cutting teeth speed
Weight
Acoustic pressure level
L 77.3 dB(A) K = 3 dB(A)
PA
Acoustic power level
L 97.3 dB(A) K = 3 dB(A)
WA
Sound power level L
WA
Guaranteed: 99 dB(A)
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
suffocation!
the hand guard.
230-240V ~ 50Hz
500 W
460mm
510 mm
16 mm
-1
n :1750 /min
0
2.2 kg
ATTENTION !
must be worn.
Weighted root mean square acceleration according
to relevant standard. :
Front handle 3.384 m / s ²
Rear handle 3.428 m / s ²
The declared vibration total value has
been measured in accordance with a standard
test method and may be used for comparing one
tool with another that the declared vibration total
value may also be used in a preliminary
assessment of exposure.
A warning that the vibration emission
during actual use of the power tool can differ
from the declared total value depending on the
ways in which the tool is used and of the need to
identify safety measures to protect the operator
that are based on an estimation of exposure in
the actual conditions of use (taking account of
all parts of the operating cycle such as the times
when the tool is switched off and when it is
running idle in addition to the trigger time).

Power supply

The hedge trimmer is designed for use only with
single-phase alternating current from a 230V 50Hz
AC supply. It is totally insulated, enabling it to be
connected also to socket-outlets without a PE
conductor.
Before you use the hedge trimmer for the first
time, check that your mains voltage is the same as
the operating voltage specified on the machine's
rating plate.

Startup and operation

Caution! This hedge trimmer is designed to cut
hedges, bushes and shrubs. Any other use which is
not expressly permitted in these instructions may
cause damage to the hedge trimmer and place the
user at serious risk. Your hedge trimmer is equipped
with a two-hand safety circuit. This means that it
works only when the switch button on the guide
handle is pressed with the one hand while the
switch on the handle is being pressed with the
other hand. If you let go of either switching element,
the blades will stop moving.
The blades take time to slow down to a
standstill. Please make allowance.
- Check that the blades are working properly. High
cutting performance and smooth operation are
guaranteed by the counter-rotating, dual-edge
blades.
- Fasten the extension cable in the corresponding
cable holder each time before you use the hedge
trimmer.
- Use only approved extension cables for outdoor
use
K = 1.5 m / s ².
K = 1.5 m / s ²..
19