CAME PS BARCODE Série Mode D'emploi page 82

14
PSIO1 Auxiliary devices controller - description
10
2
1*
1 - Terminals for 230 VAC control board * power supply
2 - Power supply protection fuse
3 - PSIO1 control board power supply protection fuse
4 - Terminals for connecting to RBMP1 or to another PSIO1
5 - Terminals for connecting input devices (Coils, Photocells,
etc.)
* The cross-section of the double insulated power cable (230 V) depends on the specifications and dimensions of the
system, and must not be less than 2.5 mm². Before connecting the device, disconnect the mains power supply to the system.
PS BARCODE -
3 4
Hardware and connections
9
8
6 - Dip Switch
7 - "Relay active" LED signal light
8 - Terminals for connecting devices to be controlled (Traffi c
lights, coils, etc.)
9 - "Communication active" LED signal light
10 - "Control board powered" LED signal
5 6
7