Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
KITEC/KITMC SERIES
Installing to a Solid Concrete Ceiling Structure
WARNING:
KITEC/KITMC Series mounts are designed to
be mounted to a concrete ceiling with a minimum thickness of
8" and a maximum drywall covering of 5/8" (1.6cm).
WARNING:
Fischer UX10 or AF8 anchors (not included)
must be installed into structurally sound solid concrete.
Installation into hollow concrete block, mortar, or concrete
that exhibits cracking, spalling, or other defects may result in
failure of anchor and serious personal injury or damage to
equipment.
1.
Using ceiling plate as a template, mark locations of four pilot
holes on ceiling.
2.
Drill pilot holes at marked locations. If using UX10 anchors,
pilot hole diameter will be 3/8". If using AF8 anchors, pilot
hole diameter will be 5/16".
3.
Install four UX10 or AF8 anchors into four drilled holes. (See
Figure 8)
4.
Loosely install two 5/16" x 2 3/4" bolts (not provided)
through two 5/16" flat washers (not provided) into opposite
anchors. (See Figure 8)
5.
Place ceiling plate up to ceiling and turn until bolts hold plate
up in position. (See Figure 8)
3
UX10 or AF8 anchors (not included) x 4
washers x 2
5
Figure 8
6.
Install two 5/16" x 2 3/4" bolts (not included) through two
5/16" flat washers (not included) through holes on ceiling
plate and into anchors. (See Figure 9)
7.
Tighten all four bolts to secure plate to ceiling. (See Figure
9)
8
Installing to Ceiling Tile
1.
NOTE:
2.
3.
x 2
4
5
x 2
6
Figure 9
Determine mounting location on ceiling.
Mounting hole does NOT need to be centered on the
tile being used for installation.
Remove ceiling tile to be used for installation from ceiling.
Cut hole in ceiling tile either by using trace template (See
Figure 12) and a drywall saw or by using a circular cutter set
to cut a hole 3 1/2" (88.9 mm) in diameter. (See Figure 10)
3
Figure 10
Installation Instructions
x 4
7
Publicité
Table des Matières
