CHIEF KITEC Série Instructions D'utilisation page 10

KITEC/KITMC SERIES
2
(N, P, Q, R or S)
Figure 14
3. Adjust height-adjustment nuts to desired level.
Figure 15)
NOTE:
Height-adjustment nuts should be adjusted as low as
possible while ensuring that the legs will always clear
any elevated surfaces on the projector. All nuts must be
adjusted to the same level to ensure an even mount.
IMPORTANT ! : The optional Universal Hardware Kit -
Long Screws (X,Y, Z, AA and BB) may be used if there is
interference with any part of the projector, and more
height is required to clear elevated surfaces of the
projector.
3
fully lowered
Figure 15
4. Place SLMU legs (K) over screw adapters and height-
adjustment nuts. (See Figure 16)
NOTE:
Make sure arm latch clips are in the unlocked position.
10
(T) x 3 or 4
(with N or P only)
screw adapters
with nuts
(See
5.
6.
WARNING:
height-adjustable nuts with the latch clips. If the legs are not
properly locked onto the adapters, the projector could fall
from the SLMU mount causing SERIOUS INJURY or DEATH!
(K) x 3 or 4
Figure 16
Press locking buttons on SLMU leg (K) firmly and
simultaneously push clip cover away from enclosed sliding
stud mount bracket until clip cover is in the locked position.
(See Figure 17)
Repeat Step 5 for remaining legs.
Make sure legs have securely locked onto
5
locking buttons
open position
Figure 17
Installation Instructions
locked position