Cleaning; Storage; Trouble Shooting; Disposal - Zipper Maschinen ZI-HAEK4100 Mode D'emploi

14.1.8 Cleaning

Clean the machine and the working attachment from dirt.
Clean the machine housing with a wet cloth and a mild cleaning solution.
Put on all coatless flats a thin coat of oil.
The usage of solvents, aggressive chemicals or scouring agents damages the machine
housing.

14.1.9 Storage

If the machine is stored for longer than 30 days:
• Let the machine cool down
• Clean the machine and dry
• Empty Tank and carburetor completely, avoid fuel spillage
• Store in a dry, out of reach of children place, well packaged.
14.1.10

Disposal

Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. Avoid damage caused by leaking
operating supplies: drain the operating supplies prior to disposal! When you buy at your
local dealer for a replacement unit, the latter is obliged to exchange your old.
15

TROUBLE SHOOTING

Shut off the machine, let it cool down, disconnect spark plug cap from spark plug
Trouble
Engine does not start
To low power
No automatically feeding of
the shredded material
Extra-ordinary sounds
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.
ZIPPER MASCHINEN GmbH
ZI-HAEK4100 / ZI-HAEK11000
N O T I C E
 Ignition switch defect
 No fuel
 Spark plug dirty or damaged
 Fuel line faulty
 less engine oil
(CAUTION: engine protection device)
 Air filter dirty
 V-belt
 Overload
 Blockage
 Blades blunt
 Blades blunt
 Screws, nuts or other parts are slack
www.Zipper-Maschinen.at
A T T E N T I O N
Possible cause
N O T I C E
TROUBLE SHOOTING
Solution
 Repair or change
 Refuel
 Clean or change
 Check fuel line for damage and
kinks
 Fill up engine oil to maximum
 Clean or change
 Tighten or change
 Reduce material feeding
 Remove shredded material
 Turn/grind blades
 Turn/grind blades
 Fix parts
38