Checking The Engine Oil Level; Checking The Fuel Tank Level - Zipper Maschinen ZI-HAEK4100 Mode D'emploi

12.3.1 Checking the engine oil level

Too low an oil level will damage the engine and shorten the life of the machine.
Therefore, check the engine oil level before every start and top up the engine oil if
necessary.
12.3.2

Checking the fuel tank level

Observe the safety regulations for fuel control. Filter the fuel during refuelling to
prevent foreign particles from entering the combustion chamber. Wipe up leaked fuel.
ZIPPER MASCHINEN GmbH
ZI-HAEK4100 / ZI-HAEK11000
N O T I C E
N O T I C E
1. Screw on the tank cap (sits on the fuel tank).
2. Level check in the form of a visual inspection. If necessary, top up with fuel
with the appropriate octane number (RON 95).
3. Close the fuel filler cap tightly after refuelling.
www.Zipper-Maschinen.at
1. To check the engine oil level, place the machine
on a safe, level surface. Switch off the engine and
allow the machine to stand for ten minutes so that
the circulating oil can collect in the oil pan.
2. Unscrew the oil dipstick and wipe with a clean,
lint-free cloth or a non-fibrous paper towel.
3. Push the dipstick into the opening, but do not
screw it in. (Make sure that the dipstick has really
been pushed in completely).
4. Pull out the oil dipstick again and read off the oil
level. There are two markings for this - see
illustration on the left.
5. If the oil level is low, refill the recommended oil up
to the upper edge (maximum filling volume:
approx. 0.5 litres).
6. Push in the oil dipstick again and tighten.
ASSEMBLY
32