Checklist Before Each Use - Zipper Maschinen ZI-HAEK4100 Mode D'emploi

After finalized assembly check all screw connections and retighten if
necessary!
12.3

Checklist before each use

The use of paint thinners, petrol, aggressive chemicals or abrasives leads to material damage
to the surfaces! Therefore use only mild detergents for cleaning!
Clean the machine and remove dirt and dust if necessary.

If the air filter is dirty, blow the filter cartridge from the inside by moving a jet of dry

compressed air up and down. Continue until all dust has been removed. Replace the
air filter with a new one if necessary.
Check the carburettor for external dirt and dust and clean it with dry compressed air if

necessary.
Check the nuts and bolts for tightness. (Screws or bolts loosened by vibrations can

lead to accidents!)
ZIPPER MASCHINEN GmbH
ZI-HAEK4100 / ZI-HAEK11000
N O T I C E
www.Zipper-Maschinen.at
In-feed:
Place the in-feed on the blades
chassis so that the mounting
holes coincide with the holes on
the in-feed.
Fix with washers and nuts.
Attention: Risk of cutting!
Safety switch / battery
connection:
Safety switch:
Establish the plug connection of
the 2-pin plug (1)
Battery:
Connect the (+) and (-) poles of
the starter cable to the one on
the battery.
Discharge chute:
Place the discharge chute on the
blades chassis so that the
mounting holes coincide with the
holes on the discharge chute.
Fix with screws, washers and
nuts.
W A R N I N G
ASSEMBLY
31