Water Filter - Bosch TES 501 Série Notice D'utilisation

en
4. Lift the water tank lid (17).
5. Remove and rinse the water tank (16)
and ill it with fresh cold water. Do not ill
above the max mark.
6. Replace the water tank (16) and push it
irmly downwards into place.
7. Close the water tank lid (17).
8. Fill the bean container (1) with coffee
beans (for preparation using ground
coffee see „Preparation using ground
coffee" auf Seite 30).
9. Press the power on/off switch O / I (9) to
switch on the appliance. LED
F
and LED lights up.
10. Place a container under the milk frother
outlet (6).
11. Carefully pull out the milk frother (6)
to open it. The appliance rinses out
the milk frother (6) with water. LED
lashes.
F
12. When LED
press in the milk frother (6) to close it.
The appliance heats up and rinses. Some
water will run out of the coffee outlet. When
A B
buttons (12),
up, the appliance is ready for use.
Switching off the appliance
If the appliance has not been used for
an hour, it rinses automatically and then
switches off (the length of time can be ad­
justed, see "Settings", "Automatic switch­off"
on page 28).
Exception: The appliance switches off with­
out rinsing if only hot water or steam was
dispensed.
To switch the appliance off manually before
this, press the service button (12). The ap­
pliance rinses and switches off.
Note: If the appliance is being used for the
irst time, the service programme has been
run, or the appliance has not been oper­
ated for a long period, the irst beverage will
not have the full aroma and should not be
consumed.
TES501_1DE.indb 27
D
lashes
F
lights up constantly,
C
(11) and (10) light
When the fully automatic espresso machine
is irst used, you will achieve a suitably thick
and stable "crema" only after the irst few
cups have been dispensed.
If the appliance is in use for a long period of
time, water droplets will form on the ventila­
tion slits. This is normal.
Water ilter
Using a water ilter can prevent a build­up
of limescale deposits.
A new water ilter must be rinsed before it
can be used. To do this, proceed as follows:
1. Press the water ilter irmly into the emp­
ty water tank with the aid of the measur­
ing spoon (18).
2. Fill the water tank (16) with water up to
the max mark.
3. Turn the rotary
knob (13) to position
4. Press and hold buttons
(12) simultaneously for at least
5 seconds. Either
lights up.
5. Press the start button (10) to select "on".
6. Press and hold the start button (10) for
at least 5 seconds to conirm. All of the
LEDs light up briely.
D
7. LED lashes and LED
8. Place a container with a capacity of 0.5
litres under the milk frother outlet (6).
9. Pull out the milk frother (6) to open it.
F
LED lashes.
10. Water will now low through the ilter and
rinse it.
F
11. When LED lights up constantly,
press in the milk frother (6) to close it.
12. Empty the container.
The appliance is ready to use again.
27
B A
(11) and
"off" or "on"
F
lights up.
TES501.. 08/2011
05.08.2011 15:34:46