Dometic Waeco PerfectView M9LQ Instructions De Montage Et De Service page 33

PerfectView M9LQ
Laying the monitor cable
➤ If there are no suitable options available for laying the monitor cable:
Drill a hole with a diameter of ∅ 17 mm in the position marked.
➤ Pull the monitor cable through the drill hole.
I
NOTE
You can fasten the monitor bracket using adhesive or screws.
Sticking the monitor bracket onto the dashboard (fig. c A, page 7)
➤ Remove the film from under the monitor bracket.
➤ Stick the monitor bracket to the position of your choice.
Screwing the monitor bracket onto the dashboard (fig. c B, page 7)
➤ Hold the monitor bracket within the outlines marked beforehand.
➤ Mark drilling points.
➤ Drill the holes, with ∅ 2 mm, at each of the markings.
➤ Screw the monitor holder on using 4 x 20 mm self-tapping screws.
Fastening the monitor
➤ Set the monitor on the monitor bracket and secure it with the knurled nut (fig. b,
page 7).
EN
Installing the LCD monitor
33