To Adjust Your Call'svolume - Audiovox VMO 5020 V Mode D'emploi

Device Icon:
Press this icon to access the Device
Screen.
Transfer Icon:
Press this icon while talking to transfer
audio from the unit back to the wireless
phone. You can only transfer a call after it
has been answered. Press the icon again
to return the audio from the wireless
phone to the unit.
Contacts Icon:
Press this icon to access the Contacts
List Screen. The contacts feature is
enabled only when paired with a wireless
phone.
Call Log Icon:
Press this icon to access the Call Log
Screen. The call log feature is enabled
only when paired with a wireless phone.
Bluetooth On Icon:
Press this icon to turn on the autopair
function. The unit will automatically
search for a device in the discover mode.
A2DP Icon:
The Bluetooth Music feature is enabled
only when paired with a wireless phone.
Press the A2DP icon and four control
functions will appear if the function is
supported by the wireless phone. These
are Previous, Next, Play/Pause and Stop.
Push-to-Talk Icon:
Press this icon to activate your wireless
phone's voice commands (if equipped).
NOTE: Your vehicle's steering wheel
controls (if equipped) will also
activate your wireless phone's
voice commands.
Dial Icon:
Press this icon to dial to phone number
that you entered.
Hang Up Icon:
Press this icon to end a call or reject an
incoming call.
Microphone Gain Icon:
Press the
or increase the desired microphone gain
setting by one increment.
TO ADJUST YOUR CALL'S
VOLUME
To adjust the volume while in a call,
rotate the volume control knob. The call
will remain at this volume for all future
calls and return to your previous source
volume when your call ends.
NOTE: If your volume seems too low,
make sure your phone's volume
is turned up to full while in a
Bluetooth call. If it is not full, it will
result in a low volume level. All
phones operate differently; you
may need to consult your phone's
owner's manual.
95
or icons to decrease