Appliance Description; Switch Positions; Preparations - Beem Leopard G5 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Leopard G5

Appliance description

(See illustration on the left fold-out page)
1
Lid, pusher
2
Pusher
3
Tray
4
Release button
5
Handle
6
Motor unit
7
Switch A
8
Switch B
9
Fixture
10
feed shaft
11
Attachment
12
Drive pinion
13
Screw conveyer
14
Mincing knives
15
Perforated disc
15a Small perforated disc (Ø 3 mm)
15b Medium perforated disc (Ø 5 mm)
15c Large perforated disc (Ø 7 mm)
16
Locking ring
17
Pusher for shortbread biscuits
18
Shortbread biscuit attachment
19
Sausage filling disc
20
Kebbe attachment
21
Kebbe shaper
22
Sausage filling shaft 1
23
Sausage filling shaft 2
24
User manual (not illustrated)

Switch positions

Switch A (7) and switch B (8) at "ON"
position: normal operation
Switch A (7) at "0" position: appliance
switched off
Switch A (7) and switch B (8) at "R"
position: reverse operation
20
Overload protections
The motor is protected against overload-
ing by a thermal circuit breaker. It stops
automatically in the event of overloading.
In this case, switch off the appliance and
allow it to cool for approx. 60 minutes.
CAUTION
Observe the maximum operating
time of 10 minutes.
Allow the appliance to cool down
afterwards for 30 minutes before it is
switched on again.

Preparations

Preassembly
Using as mincer (image A)
Insert the screw conveyer (13) into the
attachment (11).
Insert the mincing knife (14) with
the blades facing outwards into the
square of the conveyer screw.
Put the desired perforated disc (15a,
15b, 15c) onto the screw. The notch in
the perforated disc must lie over the
keyway of the attachment (image E).
Screw on the locking ring (16).
Making sausages (image B)
Insert the screw conveyer (13) into the
attachment (11).
Put the sausage filling disc (19) onto
the screw. The notch in the sausage
filling disc must lie over the keyway of
the attachment.
Insert the desired sausage filling shaft
(21, 22) through the locking ring (16).
Screw on the locking ring (16).
BEEM - Elements of Lifestyle
EN

Publicité

Table des Matières
loading

Table des Matières