Audiovox VXE 3010 Mode D'emploi page 83

STEERING WHEEL CONTROLS (SWC)
(if equipped)
The VXE 3010 is compatible with following steering wheel control adapters: Dietz UNICO DUAL
PLUS + cable, PAC (Pacific Accessory Corporation) SWI-PS and Metra ASWC. A 3.5 mm
female connector (labeled "SWC Interface") on the back of the head unit allows connectivity to
the adapters. Please refer to the instructions included with the adapters for detailed installation
information.
The following controls are available for most vehicles:
1. Volume Up (+)
2. Volume Down (-)
3. Mute
To access the SWC Controls for programing, touch the Steering Wheel icon on the second page of
the Main Source Menu.
SWC Programing
Up to 11 steering wheel control functions can be programmed via the built-in SWC interface. Not
all functions may be supported for each vehicle.
1. Popular OE steering wheel functions are already pre-programmed from the factory. If your
vehicle does not support the exact same functions already pre-programmed, you will need to
clear / reset the SWC interface and program in the exact functions of your vehicle. To clear /
reset the SWC interface, press and hold "Reset" for 2 seconds.
2. To begin programming the SWC interface after it has been cleared / reset, press a number
1 ~ 11, then press a function. A check mark should appear corresponding to the number
and function. Continue programming in this manner until all of the OE steering wheel control
functions are completed.
Note: Functions 1 ~ 11 must be assigned to a function on the OE steering wheel. For
example, if the OE steering wheel does not support Preset + and Preset -, then these
functions must be cleared / reset in order for the other functions to work correctly.
3. To "learn" the programming completed in step 2 above, press the "Program" button. You will
then be prompted to push each button on the OE steering wheel (for 1 second), so the unit can
learn the corresponding function.
4. SWC learning / programming is now complete.
4. Seek Up (Next)
5. Seek Down (Prev)
6. Source
Figure 31. SWC Programing Screens
83
7. Preset (+) 10. Answer
8. Preset (-) 11. BT End
9. Band