Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The life of the battery pack terminals
may be affected by foreign substances
such as dust and water etc. during
operation.
• When battery pack is not in use,
keep it away from other metal objects
like: paper clips, coins, keys, nails,
screws, or other small metal objects
that can make a connection from one
terminal to another.
Shorting the battery terminals togeth-
er may cause sparks, burns or a fire.
• When operating the battery pack,
make sure the work place is well venti-
lated.
• When the battery pack is removed
from the main body of the tool, replace
the battery pack cover immediately in
order to prevent dust or dirt from con-
taminating the battery terminals and
causing a short circuit.
Battery Pack Life
The rechargeable batteries have a lim-
ited life. If the operation time becomes
extremely short after recharging, replace
the battery pack with a new one.
Battery Recycling
ATTENTION:
FOR Li-ion Battery Pack
A Li-ion battery that is recyclable powers
the product you have purchased. Please
call 1-800-8-BATTERY for information on
how to recycle this battery.
Recommendations for use
Pack cover
Label
Be sure to use the Pack cover
• When the battery pack is not being
used, store the battery in a way that
foreign substances such as dust and
water etc. do not contaminate the termi-
nals. Be sure to attach the battery pack
cover to protect the battery terminals.
• When charging the battery pack, con-
firm that the terminals on the battery
charger are free of foreign substances
such as dust and water etc. Clean the
terminals before charging the battery
pack if any foreign substances are
found on the terminals.
The life of the battery pack terminals
may be affected by foreign substances
such as dust and water etc. during
operation.
CAUTION:
To protect the motor or battery, be sure
to note the following when carrying out
operation.
• If the motor and battery becomes hot, the
protection function will be activated and
the motor and battery will stop operating.
For safe use
• The battery pack is designed to be
installed by proceeding two steps for safe-
ty. Make sure the battery pack is installed
properly to the main unit before use.
• If the battery pack is not connected firmly
when the switch is switched on, the
overheat warning lamp and the battery
low warning lamp will flash to indicate
that safe operation is not possible, and
the main unit will not rotate normally.
Connect the battery pack into the unit of
the tool until the red or yellow label dis-
appears.
- 15 -
Terminals
Publicité
Table des Matières
