Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. Attaching Quick change chuck
Attach the Quick change chuck by
pulling the bottom collar forward and
sliding the female detent on the bot-
tom of the chuck to the square drive
on the body.
Release the bottom collar to make
sure the Quick change chuck is firmly
connected to the body.
EY9HX110E
①
EY9HX111E
①
2. Inserting the bit
Pull the top collar of the Quick change
chuck forward, then insert the bit.
Release the bottom collar to make
sure the bit is firmly connected to the
chuck.
3. Removing the bit
Pull the top collar of the Quick change
chuck forward, then pull the bit.
CAUTION: lmpact mechanism creates
heat.Square drive and acces-
sory may become very hot
and may cause skinburns. To
prevent skin burns, use work
gloves and/or allow heated
parts to cool down before han-
dling.
4. Detaching Quick change chuck
Pull the bottom collar of the Quick
change chuck forward to detach it.
②
- 10 -
Attaching or Removing
Bat tery Pack
1. To connect the battery pack:
Align the highlighted marker points
and attach battery pack.
• Slide the battery pack until it locks
into position.
Alignment marks
2. To remove the battery pack:
Push down the button and slide the
battery pack forward.
Button
Publicité
Table des Matières
