Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• When the belt hook is not used, be sure
to return it to the storing position. The belt
hook may catch on something.
This may result in an accident or injury.
• When the unit is hooked onto the waist
belt by the belt hook, do not attach driv-
er bits to the unit. A sharp edge object,
such as a drill bit, may cause injury or
an accident.
To Change the Belt Hook
Location Side
The belt hook can be attached to either
side of the unit.
1. Removing the hook
(1) Remove the nut.
(2) Draw out the hook.
2
2. Attaching the hook to the other side
(1) Insert the hook in the other side.
(2) Tighten the nut fully so that it
securely fastened.
Control Panel
(1)
(1) LED light
Before the use of LED
light, always pull the power
switch once.
Press
button.
The light illuminates with
very low current, and it
does not adversely affect the perfor-
mance of the tool during use or its bat-
tery capacity.
1
1
(3)
(2)
the LED light
CAUTION:
• The built-in LED light is designed to
illuminate the small work area tempo-
rarily.
• Do not use it as a substitute for a reg-
ular flashlight, since it does not have
enough brightness.
• LED light turn off when the tool has
not been used for 5 minutes.
Caution : DO NOT STARE INTO BEAM.
Use of controls or adjustments or performance
of procedures other than those specifi ed herein
may result in hazardous radiation exposure.
(2) Overheat warning lamp
2
Off
(normal
operation)
To protect the motor or battery, be sure
to note the following when carrying out
this operation.
• If the motor or battery becomes hot,
the protection function will be activated
and the motor or battery will stop oper-
ating. The overheat warning lamp on
the control panel illuminates or flashes
when this feature is active.
• If the overheating protection feature
activates, allow the tool to cool thor-
oughly (at least 30 minutes). The tool
is ready for use when the overheat
warning lamp goes out.
• Avoid using the tool in a way that
causes the overheating protection fea-
ture to activate repeatedly.
• If the tool is operated continuous-
ly under high-load conditions or if it
is used in hot-temperature conditions
(such as during summer), the over-
heating protection feature may activate
frequently.
- 13 -
Illuminated:
Flashing:
Overheat
Overheat
(motor)
(battery)
Indicates operation has
been halted due to motor
or battery overheating.
Publicité
Table des Matières
