Safety Instructions; General Guidelines - HQ Power VDL80FB Notice D'emploi

Masquer les pouces Voir aussi pour VDL80FB:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the VDL80FB! Please read the manual carefully before bringing this device into service.
Make sure that the device was not damaged in transit. If the device is damaged, you should contact your dealer and
postpone installation of this device.

2. Safety Instructions

Be very careful during the installation: touching live wires can cause life-threatening electroshocks.
Do not touch the device during operation as the housing heats up.
Keep this device away from rain and moisture.
Unplug the mains lead before opening the housing.
• A qualified technician should install and service this device.
• Damage caused by disregarding certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for the ensuing defects or problems.
• Do not switch the device on immediately if it has been exposed to changes in temperature. Protect the device
against damage by leaving it switched off until it has reached room temperature.
• This device falls under protection class I. It is essential, therefore, that the device be earthed. A qualified person
must carry out the electric connection.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
• Do not crimp the power cord and protect it against damage from sharp edges. Ask an authorised dealer to replace
the cord if necessary.
• Always disconnect the device from the mains when it is not in use or when you wish to clean it. Only handle the
power cord by the plug. Never pull out the plug by tugging the power cord.
• Replace the shields, lenses or UV screens if they have become visibly damaged (e.g. cracks, deep scratches) to
such an extent that their effectiveness is impaired.
• Replace the lamp if it has become damaged or thermally deformed.
• Do not look directly into the light source as sensitive people may go into epileptic seizure if they do.
• Note that damage caused by user modifications to the device is not covered by the warranty. Keep the device
away from children and unauthorised users.

3. General Guidelines

• This device is a light effect for professional use on stages, in discos, theatres, etc. This device should only be
operated with an alternating current of 230Vac/50Hz and is designed for indoor use only.
VDL80FB_v2
VDL80FB – 8" FIRE BALL
3
VELLEMAN

Publicité

Table des Matières
loading

Table des Matières