Table des Matières
Publicité
Guidance and manufacturer's declaration – ELECTROMAGNETIC IMMUNITY
The device is intended for use in the electromagnetic environment specified
below. The customer or the user of the device should assure that it is used in
such an environment.
Immunity test
Portable and mobile RF communications equipment should be used no closer to
any part of the device, including cables, unless the recommended separation
distances calculated from the equation applicable to the frequency of the
transmitter are respected.
Conducted RF
IEC 61000-4-6
Radiated RF
IEC 61000-4-3
where ���� is the maximum output power rating of the transmitter in watts (W) according to
the transmitter manufacturer and ���� is the recommended separation distance in meters
(m). Field strengths from fixed RF transmitters, as determined by an electromagnetic site
survey, could be less than the compliance level in each frequency range. Interference may
occur near equipment marked with the following symbol:
IACER Srl
EN 60601-1-
Compliance
2 Test level
3V
3V
rms
rms
from 150kHz
from 150kHz
to 80MHz
to 80MHz
3V/m
3V/m
from 80MHz
from 80MHz
to 2,7GHz
to 2,7GHz
Electromagnetic environment
level
Recommended separation distance
���������������� 150������������ �������� 800 ������������
���������������� 80������������ �������� 800 ������������
���������������� 800������������ �������� 2,7������������
30
–guidance
���� = 1,2 √����
���� = 1,2 √����
���� = 2,3 √����
MNPG326
Publicité
Table des Matières
