Interconnections
10
Part 2 Preparation
Up to fifteen Ultra Wide SCSI peripherals can be connected to the host
computer through the SCSI bus.
Use a regular Ultra Wide SCSI cable for connection. The drive uses a 68-pin
half-pitch connector.
Precautions
• Switch off the host computer and peripherals before connecting the Wide
SCSI cable.
• Make sure the Wide SCSI connectors are pressed tightly together.
• If the drive is the last (or only) device on the Ultra Wide SCSI bus, be sure
to connect a SCSI bus terminator to the unused SCSI connector.
Use a LVD terminator.
Use a single-ended terminator, if host computer uses a single-ended SCSI
adaptor.
Use of the wrong terminator may cause damage.
• With Ultra Wide SCSI, the total length of the SCSI cable(s) between the
host computer and the last device on the SCSI bus should be less than 12
meters. (It should be less than 1.5 meters, if connected to single-ended SCSI
host adaptor.)
SCSI CONNECTOR
SCSI ID
0
FG
Terminator
AC IN
AC Power