Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
64384ENv04 11/9/01 11:11 AM Page 9
Installing Attachments
wWARNING
Pinch and Crush Hazard
Make sure that the mixer is off and
unplugged before installing or
removing attachments and parts.
DO NOT reach or insert utensils into
the bowl while the mixer is running.
Failure to follow these instructions
can result in broken bones, cuts, or
other serious injury.
Always keep the appliance unplugged
during assembly and disassembly.
1. Rotate the head release lever counter-
clockwise and raise the mixer head until
it locks in the upright position.
2. Insert the bowl into the socket on the
base, aligning the notches on the bowl
with the bowl locking tabs on the base.
3. Rotate the bowl clockwise until it locks
into place.
4. Insert the shaft of the desired attachment
into the socket, pressing firmly and
rotating counterclockwise until it clicks
into place. To remove an attachment,
simply rotate it clockwise until it
disengages and pull it out.
5. Rotate the head release lever counter-
clockwise and gently lower the mixer
head until it locks in the operating
positon.
NOTE: The stand mixer has a safety
interlock that prevents the mixer from
operating when the mixer head is
raised. DO NOT attempt to defeat
this safety mechanism.
CPM700 with wire whisk shown
9
Publicité
Table des Matières
