Hamilton Beach Commercial CPM500 Manuel D'utilisation page 10

64384ENv04 11/9/01 11:11 AM Page 10
Adjusting Attachments
wWARNING
Pinch and Crush Hazard
Make sure that the mixer is off and
unplugged before installing or
removing attachments and parts.
DO NOT reach or insert utensils into
the bowl while the mixer is running.
Failure to follow these instructions
can result in broken bones, cuts, or
other serious injury.
NOTE: It may be necessary to adjust the
attachments before initial use. If the wire
whisk or beater hits against the bottom of
the bowl, or does not extend far enough
into the bowl to mix ingredients properly,
follow the instructions below:
1. Insert the attachment to be adjusted in
the mixer, following the instructions and
precautions on page 9.
2. Raise the mixer head.
3. Holding the attachment in place, use
a wrench to loosen the lock nut on
the attachment.
4. Lower the mixer head until it locks into
place.
5. Turn the attachment clockwise (to lower)
or counter-clockwise (to raise) until the
desired height relative to the bottom of
the bowl is reached.
6. Raise the mixer head.
7. Holding the attachment, tighten the lock
nut firmly.
10 10
CPM700 with wire whisk shown