Inspections And Maintenance - Güde GA 1000 D Traduction Du Mode D'emploi D'origine

Clean the filter
After some time, the filter gets slightly clogged by ash. To get
full power, pres the suction tube at an angle to the ground (pic.
3).
Clean or replace the filter after finishing your work
When cleaning, remove rough dirt first by rolling (pic. 5).
Then you can clean the filter with water (pic. 6).
Dry out the filter first before installing it in the appliance.
The filter must be replaced when there is obvious external
damage or before.

Inspections and maintenance

Safety instructions for inspections and maintenance
The appliance, especially the suction nozzle needs to be
cleaned after any use!
Regular maintenance is necessary for proper working of
your appliance.
Regular cleaning and maintenance of the suction nozzle must
especially be carried out to prevent damage and accidents in
general.
The following needs to be provided before maintenance:
- disconnect the plug,
- put the appliance to a stable position,
- wait until the engine cools down.
Have any repairs unconditionally executed by trained
professional staff.
Disconnect the plug before every alteration, adjustment or
maintenance of the appliance!
Cleaning
Always keep the appliance clean and in working order!
Clean the engine with just a cloth.
Avoid spraying with heavy water stream.
Filter cleaning
To maintain the maximum suction power of the ash vacuum
cleaner, rough cleaning of the filter is recommended (after
each use if possible). If possible, clean the filter outside to
prevent your home from becoming dirty.
Take the ash vacuum cleaner and hit it hard on the floor for 3-5
times (pic. 3) so that the coarsest pieces of dirt fall off the metal
filter screen.
Le the vacuum cleaner stand for 2-3 minutes to allow dust to
settle down in the vacuum cleaner.
Open the container lid, remove the filter by slight clockwise
rotation and clean it by tapping the outer dust layer on the
container inside out on the ash (pic. 4).
If the exhaust power does not significantly improve, the filter is
damaged and it must be replaced (spare filter – product number
16717).
CAUTION! Then, if possible, perform a short test run
outdoors to release dust particles produced during
replacement or cleaning.
Service
Do you have any technical questions? A claim? Do you
need spare parts or the Operating Instructions?
You will be helped quickly and without needless bureaucracy at
our webpage www.guede.com in the Services section.
Please help us be able to assist you. To identify your machine
when claimed, we need to know its serial No., order No, and
year of production. All these details can be found on the type
label. Enter the details below for future reference.
Serial No.
Order No.
Year of production:
Tel. +49 (0) 79 04 / 700-360
Fax: +49 (0) 79 04 / 700-51999
Email: support@ts.guede.com
Important information for the customer
Please be sure to know that returning the product in or after the
warranty period must be made in the original packaging.
Optional supply
SPARE FILTER
Art. No. 16717
EAN: 40 15671 22782 9
11