Removing The Unit - Kenwood DPX-5200BT Mode D'emploi

Installation/Connection

Removing the unit

1
Fit the catch pin on the extraction keys into the holes on both
sides of the trim plate, then pull it out.
2 Insert the extraction keys deeply into the slots on each side, then
follow the arrows as shown on the illustration.
30
ENGLISH
Connect external components
No Part
1 Microphone input jack (Page 15)
2 Output terminals
FRONT: Front output (2-way crossover)/Mid Range output (3-way crossover)
REAR /SW: Rear/Subwoofer output (2-way crossover)/Woofer output (3-way
crossover)
• When connecting an external amplifier to the output terminals of this unit, securely
connect the amplifier ground wire to the car chassis to prevent damage to the unit.