Publicité
Les langues disponibles
Les langues disponibles
Spray onto the adhesive residues with 1 K-PUR/ASK-Cleaner R540 and
remove them with the spatula.
Check the result of the bulge process. In case of a heightening of the sheet the area
has to be flattened carefully with the nylon-pen. Clean the treated surface again.
The process has to done again if a deformation is still viewable.
Attention:
At new coated sheet parts the new paint can be separated when the adhesion between the
coatings is not acceptable.
is deep and sharp.
is quite deep but unsharp.
Not deep and unsharp dent which also
can arise during the bulge process.
Types of dents
The A-dent
The B-dent
The C-dent
Types of dents
Types of dents
Types of dents
Publicité
