Security-Center PROFILINE TV7330 Instructions D'installation page 46

This submenu applies to VIDEO mode:
Program the camera as follows:
VIDEO MENU
CHROMA
HUE
BRIGHT
PEDESTAL
SPRS EFCT
SPRS GAIN
RETURN
1. Move the cursor to select CHROMA. Looking at the monitor or oscilloscope, adjust the
chroma level by sliding the "I" cursor using the RIGHT/LEFT keys. The higher the CHROMA
level, the higher the colour depth of the picture.
2. Move the cursor to select HUE. Looking at the monitor or oscilloscope, adjust the hue by
sliding the "I" cursor using the RIGHT/LEFT keys.
3. Move the cursor to select BRIGHT. Looking at the monitor or oscilloscope, adjust the
brightness of the picture by using the RIGHT/LEFT keys to enter a value.
4. Move the cursor to select PEDESTAL. Looking at the monitor or oscilloscope, adjust the
pedestal by using the RIGHT/LEFT keys to enter a value. Use a high pedestal for
insufficient illumination.
I ° ° ° I ° ° ° I
I ° ° ° I ° ° ° I
90
7.5IRE
120
48
5. Move the cursor to select SPRS EFCT. Adjust the chroma value responsible for calculating
the switchover time for automatic switching from day to night mode. The higher the value,
the longer the switchover delay in poor light conditions. The factory setting is ca. 2 lux.
6. Move the cursor to select SPRS GAIN. Adjust the value responsible for the colour factor in
night operation. If you change this value to 0, you get a pure B/W picture. A higher value
gives you a coloured but very noisy picture.
46