Zanussi ZDT15003 Notice D'utilisation page 26

The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
Limescale particles on the
dishes.
Whitish streaks and stains or
bluish layers on glasses and
dishes.
Dry water drop stains on
glasses and dishes.
The dishes are wet.
26
Possible cause
The filters are clogged.
The filters are not correctly assembled
and installed.
The spray arms are clogged.
The programme was not applicable for
the type of load and soil.
Incorrect position of the items in the
baskets. Water could not wash all items.
The spray arms could not turn freely.
The quantity of detergent was not suffi-
cient.
There was no detergent in the detergent
dispenser.
The salt container is empty.
The set level of the water softener is in-
correct.
The cap of the salt container is loose.
The released quantity of rinse aid is too
much.
The quantity of detergent was too much.
The released quantity of rinse aid was
not sufficient .
The quality of the detergent can be the
cause.
• The programme had no drying phase.
• The programme had a low tempera-
ture drying phase.
Possible solution
Clean the filters.
Make sure that the filters are correctly as-
sembled and installed.
Remove remaining soil with a thin pointed
object.
Make sure that the programme is applica-
ble for the type of load and soil.
Make sure that the position of the items in
the baskets is correct and that the water
can easily wash all items.
Make sure that the position of the items in
the baskets is correct and does not cause
the blockage of the spray arms.
Make sure that you add the correct quan-
tity of detergent in the dispenser before
you start a programme.
Make sure that you add detergent in the
dispenser before you start a programme.
Make sure that there is dishwasher salt in
the salt container.
Make sure that the set level of the water
softener agrees with the water hardness in
your area.
Tighten the cap.
Decrease the released quantity of rinse aid
.
Make sure that you add the correct quan-
tity of detergent in the dispenser before
you start a programme.
Increase the released quantity of rinse aid.
Try a different brand of detergent.
For better drying results, keep the door
ajar for some minutes.