Zanussi ZDT15003 Notice D'utilisation page 21

Manual adjustment
1
Electronic adjustment
1. Press the on/off button to activate the appliance.
2. Make sure that the appliance is in setting mode. Refer
to 'SETTING AND STARTING A PROGRAMME'.
3. Press and hold function buttons (B) and (C) at the
same time until the indicators of function buttons (A),
(B) and (C) flash.
4. Press function button (A).
• The indicators of function buttons (B) and (C) go
off.
• The indicator of function button (A) continues to
flash.
• Intermittent acoustic signals operate and the end
indicator flashes showing the setting of the water
softener.
– The number of flashes of the end indicator and
the number of the acoustic signals show the
level of the water softener.
Example: 5 acoustic signals and 5 flashes +
pause + 5 acoustic signals and 5 flashes = level
5.
5. Press function button (A) again and again to change
the setting. Each time you press function button (A)
you go to the next level.
6. Deactivate the appliance to confirm.
Filling the salt container
Caution! Only use dishwasher salt. Other products
can cause damage to the appliance.
Water and salt can come out from the salt container when
you fill it. Risk of corrosion. To prevent it, after you fill the
salt container, start a programme.
2
Turn the water hardness
dial to the position 1 or 2.
1
3
Put 1 litre of water in the
salt container (only for the
first time).
5
Filling the rinse aid dispenser
Caution! Only use rinse aid for dishwashers. Other
products can cause damage to the appliance.
The rinse aid, during the last rinsing phase, helps to
dry the dishes without streaks and stains.
2
4
6
21