Operation - Beyerdynamic DT 100 Notice D'utilisation

made, use a high-temperature solder-pot to tin the tinsel conductors
before making the solder joint to the connector, but be careful
that the nylon thread does not melt. Direct solder connections
can be made to all other bare-ended cables (for cable
connections, please refer to "Wiring Diagram"). On request,
the necessary plugs can be fitted when the order is placed.

Operation

The DT 100/102 studio headphone and the DT 108/109
headset are professional products. It is important that the
external equipment they are connected to is of similar quality
and has the correct impedance and power ratings to achieve the
best performance. Please refer to the "Technical Specifications"
for detailed information.
Convention states that when using the DT 108/109 the boom
microphone is placed over the left ear. The microphone can be
used from the right ear, but if true L and R headphone status
needs to be maintained, it will be necessary to make a custom
lead with the headphone connections reversed (swap brown/
orange on the left side and red/blue on the right side). For
connections refer please to "Block Diagram".
Tighten flat screw and put cap on turning knob.
4
Lift cap with small
1
screwdriver.
2
Loosen flat screw.
Turn disc 180°. Nose of the
3
disc points to the upper end.
of the boom arm.
12