Troubleshooting; Potential Types Of Problems - Brother QL-650TD Guide De L'utilisateur

48
STEP4 Maintenance and Troubleshooting
2

Troubleshooting

If problems occur while using this printer, the following may help you to solve the
problems:

Potential types of problems

Problem
•
Cannot print
•
Printing error
is displayed
•
LED lamp
does not light
up
•
LED lamp is
blinking
•
The print
quality is poor
•
Data
transmission
error is
displayed on
PC
•
The clock
stops when
unplugging
the power
cord
•
Is the USB cable disconnected?
Check the USB cable is connected properly.
•
Is the DK Roll properly set?
If it is not set properly, remove the DK Roll and set it again.
•
Is the DK Roll used up?
•
Is the DK Roll cover open?
Check the roll cover is closed properly.
•
Are both the USB cable and RS-232C cables connected to the
printer at the same time?
Connect only one cable which is used to communicate with the
printer.
•
Is the power cord connected properly?
Check the power cord is connected properly. If it is connected
properly, try to connect it to another outlet.
* If the problem is not resolved after trying these solutions, contact your local
distributor or Brother Call Center.
•
For details, See "Manual operation button" on page 15.
•
Does a system error (the LED turns off after blinking 10 times)
occur?
Turn OFF the power to the printer wait 30 seconds and then turn it
ON again.
If the problem is not resolved after trying this solution, contact your
local distributor or Brother Call Center.
•
Is the print head or roller damaged or stained?
The print head is cleaned when using the DK Roll (thermal recording
paper), however, dust or stains from the roller may collect on the
print head. In this case, clean the roller. For details, See "Roller
maintenance" on page 42.
•
Is the correct port selected?
Check that the correct port is selected from [print to the port below]
in printer property dialog box.
•
Is the battery protection sheet removed?
Remove the battery protection sheet.
•
Is the battery installed?
Put a new battery in the machine.
•
The battery has run out of power.
Replace it with a new battery.
Solution