Attaching The Paper Guide - Brother QL-650TD Guide De L'utilisateur

4
Check that the roll release lever
is in the up position.
Thread the end of the DK Roll
into the slot immediately in front
of the cutter.
When unable to thread the end of
the DK Roll fully into the slot, thread it
as far as possible. Lower the label lever
and close the cover, then press the Feed button
5
Push down the roll release lever and close the
DK Roll cover.

Attaching the paper guide

5
The printer contains a paper guide which can hold up to 10 individual label sheets.
1
Attach the paper guide to the
front of the printer as shown
on the right.
You will need to remove the
paper guide if you wish to print
and cut more than 10 labels at a
time.
Roll release lever
Cutter
Printing unit
to set the roll.
( )
Paper guide
FRANÇAIS
17
STEP
1
STEP
2
STEP
3
STEP
4