Clean Remote Control; Elimination Of Faults - Schluter Systems LIPROTEC LT EBR 1 Notice D'utilisation

EN

Elimination of faults

9.3 Clean remote control

Malfunction due to moisture.
The remote control is not protected against moisture; this
may cause malfunctions or defects.
Keep the remote control away from liquids and

moisture.
Wipe contamination off the remote control with a dry,

non-linting, soft cloth.
10 Elimination of faults
If faults or malfunctions of the LIPROTEC
system occur, always check the status displays
of the Bluetooth receiver (see chapter "Status
displays").
Fault Cause of
fault
Circuit Power pack
breaker is defective
triggered
Mains cable
or socket
defective or
incorrectly
connected
62
CAUTION!
Troubleshooting
Replace the power pack
Have a qualified electrician
check and, if necessary, repair
the power pack's mains cable
and the socket
Bluetooth receiver directions for use