Clean Remote Control - Schluter Systems LIPROTEC LT EBR 1 Mode D'emploi

EN
Elimination of faults
In order to change the battery of the remote control, please
proceed as follows:
Have a new lithium battery (type CR2032) ready.

To open the battery compartment, slide the cover (see

fig. D, item 1) in the direction of the arrow.
Lift the battery (see fig. D, item 2) out of the battery

compartment.
Insert the new battery into the battery compartment.

Place the cover with the hooks into the four slots on the

battery compartment and press them in gently.
The cover audibly clicks into place.

To close the cover, slide it in the opposite direction to the

arrow up to the stop.

4.3 Clean remote control

Malfunction due to moisture.
The remote control is not protected against moisture; this
may cause malfunctions or defects.
Keep the remote control away from liquids and

moisture.
Wipe contamination off the remote control with a dry,

non-linting, soft cloth.
26
CAUTION!
Bluetooth receiver operating instructions