Program Mode; Basic Navigation - IRT Hyperion IRT 4-1 PcAuto Mode D'emploi

7. Program mode - General rules for navigation in the software
– The display shows software defi ned options in the bottom corner fi elds.
To adjust the values use the arrow keys.
– To move to previous display without saving, press cancel
7.1

Basic navigation

There are twelve predefi ned programs and three empty ones. All 15 programs have editable positions, names and drying parameters. Scroll up or
down using the arrow keys, press select to run the program or view to edit.
1. Putty
2. Filler
3. Waterfi ller
4. Waterbase
5. Basecoat
6. Topcoat
7.2
7.2.1 Distance check
The distance is indicated on the display as
"too close", "too far" or "correct". If measur-
ing fails "check distance manually" appears.
Use the buttons on the keyboard to alter
Stop or cancel
between one or two active
returns to 7.1.
cassettes and to turn on/off the temp. control.
See chapter 8.1.
7.2.2 Start drying
Press start to begin the drying sequence. The
remaining time of the "fl ash off" will start
counting down. When the count down is
fi nished, the program automatically changes
to full bake mode.
7.2.3 Program graph
This graph is available when the temperature
control is active. The graph describes the tar-
get, actual temperature, and remaining time.
See chapter 8.1.
7.2.4 Program values
These are the same values as shown in pro-
gram graph, but also the used power capacity
of the machine.
Note! An inactive temperature control does
not show temperature values.
7.2.5 Drying complete
When fl ash off and full bake times have expired the software returns
to 7.1.
Note! To extend the lifetime of the lamps, the ventilators will continue
to run for cooling. After three minutes they turn off automatically.
Note! When the drying program is completed the
temperature control will automatically reactivate.
713687 rev 5
IRT 4-1 PcAuto, IRT 4-2 PcAuto, IRT 4-10 PcAuto and IRT 4-20 PcAuto
7. Clearcoat
8. Plast Filler
9. Plast Topcoat
10. PlastiClearcoat
11. Final boost
12. Soft cure
Run
.
13. Free prog
14. Free prog
15. Free prog
7.3
7.3.1 Properties
The values of the chosen program will show
on the display.
By pressing the "Temperature control" button
the software switches between the properties
Stop or cancel
with and without the temperature control.
returns to 7.1.
A change in either property is independent of
the other one. See chapter 8.1 for more info.
7.3.2 PIN Code
Use the arrow keys to set the correct digit.
Press enter to confi rm and to edit the sec-
ond, third and fourth digit in the advanced
Use arrow keys
PIN code.
to set numbers.
Note! An entered PIN code is valid for all
entries until the main switch is turned off.
See chapter 9.2 for "advanced PIN code".
7.3.3 Edit program parameters
When marked, change the value of the pa-
rameters with the arrow keys. Press enter
to change the next value and so on. Pressing
enter for the last value directs the user to
The program returns
editing of program position and name.
to 7.3.1.
Press cancel to exit to 7.3.1 without saving
any parameters.
7.3.4 Edit prog. position/name
When marked, change the program number
with the arrow keys. Press enter to confi rm
The program returns
and to edit the next symbol.
to 7.3.1.
Note! Changing the number will also
change the program position in the program
list.
Edit
5