Maintenance And Service; Filter Replacement - IRT Hyperion IRT 4-1 PcAuto Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27
11.

Maintenance and service

Weekly
Check that all IR lamps light up during mobile dryer opera-
tion. Defect IR lamps can cause uneven heat distribution
over the surface.
Clean the dryer from dust, which can be a cause of fi re, with
a damp cloth. Also, check that all cables are undamaged. A
damaged cable can be a danger to life!
Monthly
Check the gold refl ectors. Damaged or extremely dirty refl ec-
tors can over heat the refl ector body and/or the cassette. In
case of doubt, please contact the customer service in order
to clarify if the gold coated refl ector needs to be changed.
Yearly
Plan to change the air fi lter approx. once per year. You will
get a message in the software when it is time to change.
When starting up the dryer you will get an indication on
how much of the fi lter time that is used.
11.1

Filter replacement

Attention! The fi lters are disposable and should not be
reused.
1. Use a knife or screw driver to bend loose the two plastic
plugs at the cassette side plates.
2. Remove the used fi lter.
3. Insert the new fi lter so the IRT logo is visible from
the outside.
4. Place the long side of the fi lter opposite to the two plug
holes on the cassette according to picture.
5. Push in the fi lter until the two plastic "push-in-plugs" can
be reattached.
6. Reset the fi lter timer, see chapter 9.4.17
713687 rev 5
IRT 4-1 PcAuto, IRT 4-2 PcAuto, IRT 4-10 PcAuto and IRT 4-20 PcAuto
11.2
IRT lamp replacement
Attention! Do not touch the gold coated
refl ector or the new IR lamp with your fi ngers.
Only remove the protective paper on the IR lamp
after you have installed it.
1. Disconnect power supply.
2. Loosen the three top screws on the front plate of the
2 kW
3. Disconnect the cable connector.
4. Loosen the four screws at the ends of the
5. Remove the mesh and unscrew the lamp from
6. Install new lamps in the reverse order.
cassette.
1 kW
1 kW
refl ector and remove the refl ector from the
plate.
the two ends.
2 kW
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Irt 4-2 pcautoIrt 4-10 pcautoIrt 4-20 pcauto

Table des Matières