Turning On The Appliance; General Operating Indications; Adjusting The Cup/Espresso Cup Height - Caffitaly System S08 Mode D'emploi

• Fill the tank with fresh, still water (Fig. 4).
• Switch on the appliance by pressing the power on/off switch (Fig. 14).
• Warning lights A-B-C-D will blink simultaneously to indicate that the machine is warming
up.
• When warning light D and the light indicated by the knob (A,B or C) are lit steadily, and
the machine beeps twice, the machine is ready to use.
DESCALING SIGNAL:
• When warning light D blink YELLOW every 5 seconds, a descaling cycle should be
carried out (see ch. Descaling).
HEATING:
• Warning lights A-B-C-D blink simultaneously.
WHEN THE WATER RUNS OUT DURING OPERATION:
• The water tank is empty when indicator light D blinks RED and the appliance emits 3
beeps followed by a single intermittent beep.
• Fill the water tank with fresh, still water (Fig. 4).
• Press button E. Wait for the machine to complete the priming cycle and fi ll with water.
• When warning light D and the light selected by the knob (A,B or C) are lit steadily, the
machine is ready to use.
IF THE LEVER IS RAISED WHILE DISPENSING:
• Raising the lever while dispensing a product (Fig. 1) may cause splashes of hot water.
Danger of scalding!
• Warning light D blinks RED. The appliance will immediately stop dispensing.
• Close the lever (Fig. 3).
• Press button E to reset the alarm.
• The appliance is ready for use again.

Adjusting the cup/espresso cup height

• The machine can be adjusted for the use of large cups or espresso cups.
• The machine is initially set for the use of large cups (Fig. 7).
• For the best possible results when using espresso cups, raise the drip tray, expand the
bottom part and fi x it in place by turning it clockwise (Fig. 10).
• Reposition the drip tray and start using the espresso cups (Fig. 8).
English

Turning on the appliance

General operating indications

35