Connecting To The Power Supply; Operating Instructions; Starting Up For The First Time - OFFCAR S.700 Notice D'installation, D'utilisation Et De Maintenance

1.3 CONNECTING TO THE POWER SUPPLY

- To connect the power supply, identify the junction box inside the appliance and connect the power cable with a
standardised plug that is adequate to the power intake. Follow the instructions on the terminal clamp. Plug the
plug into a power socket that has been properly earthed in compliance with current legislation.
N.B.: if the appliance has two junction boxes, connect two separate cables (one for each box) in the manner
specified above and then connect the cables to the power sockets. Two not make any bridge connection between
the two junction boxes.
- Before connecting the appliance directly to the main power supply, fit a circuit breaker of adequate capacity
whose contacts have a minim distance of 3 mm.
- When the machine is operating the power supply must not deviate from the nominal supply by more than ±
10%.
- The equipment must also be part of an equipotential system whose efficiency must be tested to ensure
compliance with current regulations.
Before delivering the appliance to the user:
- check that it operates correctly,
- instruct the user on how to use it.
2.

OPERATING INSTRUCTIONS

The appliance must be used only for the purpose for which it was designed. Any other use is improper.
During operation, supervise the appliance.

2.1 STARTING UP FOR THE FIRST TIME

WARNING: do not start up the appliance before filling the frying compartment with oil. Failure to comply with this
requirement result in grave damage from an overheated frying compartment and overheated heating elements.
Before starting up the appliance for the first time remove all the packing and thoroughly clean the protective
industrial grease from the tray and containers using this procedure:
- fill the tank to the brim with water and normal detergent, turn on heat and boil for a few minutes.
- drain the water through the drain tap and rinse the tank with plenty of clean water;
- shut off the tap and pour in frying oil above the MIN mark and below the MAX mark.
Fig. 2
- Before connecting to the power supply, make
sure that the power supply is compatible
voltage and frequency values displayed on the
rating plate.
- The supplied appliance is designed to perform
the operation specified on the rating plate
located inside the door.
Pag. 9