Options; Acoustic Signals - Atag VA61111MT Notice D'utilisation

1)
Programme
P5
P6
P7
1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of
dishes can change the values.
Information for test institutes
For all the necessary information for test performance. send an email to:
info.test@dishwasher-production.com
Write down the product number (PNC) that is on the rating plate.

OPTIONS

Activate or deactivate the options be-
fore the start of a programme. You
cannot activate or deactivate the op-
tions while a programme operates.
If one or more options are set, make
sure that the related indicators are on
before the programme starts.
Half-load
Activate or deactivate this option be-
fore the start of a programme. You
cannot activate or deactivate this op-
tion while a programme operates.
Set this option when you want to wash a
small quantity of tableware and cookware.
This option decreases the programme du-
ration and the consumption of energy and
water.
Load the upper basket and the lower bas-
ket and decrease the quantity of detergent.
Multitab
Activate this option only when you use the
combi detergent tablets.
This option deactivates the use of rinse aid
and salt. The related indicators stay off.
The programme duration can increase.
How to activate the Multitab option
1.
Press , the related indicator
comes on.
Duration
(min)
195
14
30
Energy
(kWh)
1.03
0.1
0.8
If you stop to use the combi detergent
tablets, before you start to use
separately detergent, rinse aid and
dishwasher salt, do these steps:
1. Set the water softener to the highest
level.
2. Make sure that the salt container and
the rinse aid dispenser are full.
3. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
4. Adjust the water softener to the water
hardness in your area.
5. Adjust the released quantity of rinse aid.

Acoustic signals

The acoustic signals operates when the ap-
pliance has a malfunction. It is not possible
to deactivate this acoustic signal.
There is also an acoustic signal that oper-
ates when the programme is completed. By
default, this acoustic signal is off, but it is
possible to activate it.
How to activate the acoustic signal for
the end of programme
1. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode, refer to "Setting and
starting a programme".
2. Press and hold, at the same time,
and
and indicators start to flash.
3. Press
.
Water
(l)
11
4
4
until the ,
19