Setting Mode - Atag VA61111MT Notice D'utilisation

22
2. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode, refer to 'Setting and
starting a programme'.
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill the
rinse aid dispenser.
Using the detergent
D A B
30
20
A B D
3 0
2 0
Setting and starting a
programme
The Auto Off function
To decrease the energy consumption, this
function automatically deactivates the appli-
ance a few minutes after:
• You have not closed the door to start the
programme.
• The programme is completed.

Setting mode

For some settings it is necessary that the
appliance is in setting mode.
The appliance is in setting mode when, af-
ter the activation, the display shows pro-
gramme ECO.
C
A
-
+
C
3. Load the baskets.
4. Add the detergent.
• If you use the combi detergent tab-
lets, activate the multitab option.
5. Set and start the correct programme for
the type of load and the degree of soil.
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent in the compartment (D).
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
If the control panel does not show this con-
dition, press RESET. The display shows
programme ECO.
Starting a programme without delay
start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode.
3. Press one of the programme buttons
until the display shows the number of
the programme you want to set.
• After some seconds the display
shows the programme duration.
4. Set the applicable options.
5. Close the appliance door to start the
programme.