Install Pcset Graphic Software; System Requirements; Supported Operating Systems; Installing Software - Reiner jetStamp graphic 970 Mode D'emploi

jetStamp graphic 970

1.4. Install PCset graphic Software

1.4.1. System Requirements

Supported REINER devices:
- jetStamp graphic 970
- speed-i-Marker 940
Hardware:
- PC with Pentium processor (also compatible) or higher
- Graphics adapter with a min. resolution of 800 × 600 pixels
(at least 256 colours; optimal: TrueColor, 24 Bit, 16.78 million colours)
- RAM, at least 32 MB
- 10 MB free hard disc memory
- 1 free USB interface

Supported operating systems

- Windows 2000, Windows XP, Windows XP 64-Bit
- Windows Vista, Windows Vista 64-Bit, Windows 7, Windows 7 64-Bit

1.4.2. Installing Software

Installation is only possible with administrator rights on the computer.
Insert PCset graphic-CD into the drive.
f
If the installation programme does not start up automatically, start the file "setup.exe".
f
Observe the installation programme instructions.
f

1.5. Prepare jetStamp graphic 970 for PCset graphic

Prepare jetStamp graphic 970 for PCset graphic
For the device to be correctly recognised by the computer, the PCset graphic software
must be installed first.
Connect the micro-USB socket to the computer via the USB cable
f
Turn the set wheel
f
The PC recognises the jetStamp graphic 970 as a new USB device.
The device driver software is installed automatically.
When the device is connected to the PC, the rechargeable batteries are
charged via the USB connection.
48
1
7
to to activate the device.
Fig. +
A C

9
.